compactpci/picmg 2.16 pentium core-duo sbc dynatem inc., (800)543-3830, (949)855-3235, fax: (949)770-3481, email: sales@dynatem.com , w eb: www .dynatem.com CPD2 the CPD2 is a 6u single-slot compact pci (pcmg 2.16 compatible) platform based on the intel? core?2 duo mobile processor l7400 at 1.5 ghz or the t7400 at 2.16 ghz . the CPD2 takes advantage of the core2-duo s low 17 w power consumption (at 1.5 ghz) as a rugged single board computer (sbc) and it is optionally available as a conduction-cooled compact pci module with wedge locks and a full-board heat sink for high shock/vibration environments and temperature extremes. for the conduction-cooled version, see crd2. the e7520 memory controller hub (mch) and 6300esb i/o controller hub (ich) chipset supports pci-x and pcie expansion, usb 2.0, a t a/100, and serial a t a (sata). two gb ethernet ports and two usb 2.0 ports are accessible from the front panel in addition to two pmc bezels. 16 gb of on-board flash permits sin- gle-slot booting. two picmg 2.16-compliant, 10/100/1000basetx ports are routed to the backplane. two sa ta ports, vga video,up to four com ports, an optional ide interface, ps/2 mouse & keyboard, and two more usb 2.0 ports are routed to the backplane. two pmc-x site is provided for additional i/o expansion. one of the sites is xmc compatible and supports x8 pciexpress. conventional pc i/o is accessible with industry-standard connectors on optional rear i/o modules. e7520 & 6300esb chipset two x4 pci express interfaces are routed to two dual gb ethernet controllers two x4 pci express interfaces are routed to the two pmc sites via two tsi384 pcie to pci-x bridges. this provides each pmc site with a dedicated 64-bit 133 mhz pci-x bus with a 1 gb bandwidth one x8 pci express interfaces is routed to an xmc site ddr2-400 dram interface with a max memory band width of 6.4 gb/second four usb 2.0 ports pata/100 and sata/150 support pci-x 64/66 for the plx pci6466 pci/pci bridge pci 32/33 for sm712 vga controller core?2 duo mobile processor 1.5 ghz or 2.16 ghz, 479-pin ufc-bga core 2 duo manufactured with low-power 65 nm process 4 mb l2 cache 667 mhz front side bus 64-bit os and application support single-slot operation single-slot compactpci operation with 16 gb of on-board flash disk for bootable mass storage
dynatem inc., (800)543-3830, (949)855-3235, fax: (949)770-3481, email: sales@dynatem.com , w eb: www .dynatem.com d ram 2 or 4 gbytes of ddr2-400 memory two banks that are each 64 bits wide with ecc support compactpci picmg 2.0 r3.0 compliant plx non-transparent pci-pci bridge provides 64-bit compactpci transfer rates at 66 mhz universal bridge lets the CPD2 operate as a system controller or a peripheral slot module supports hot swapping according to picmg 2.1 r2.0 connectors j3 and j5 are used for i/o expansion pmc expansion two pmc sites each with a dedicated 64-bit 133 mhz pci-x bus interfaced to the e7520 via two separate tsi384 pcie to pci-x bridges. this architecture provides 1 gb access to e7520 one of pmc sites supports xmc modules with x8 pcie ethernet/picmg 2.16 t wo intel 82571eb dual pci express ethernet controllers provide a total of four 10/100/1000basetx ports t wo ports routed to the front panel t wo ports routed to the j3 connector in compliance with picmg 2.16 for backplane fabric switching or for alternate routing to an optional rear i/o card graphics the silicon motion sm712 ultra low-power display controller with 4 mb on-chip memory vga routed to j5 ide/flash primary ata/100 dma ide interface is optionally accessible from the j5 secondary ide port is routed to a silicon motion sm- 2231 nand flash controller. 16 gb of nand flash is installed bios phoenixs flash-based system bios with boot options including cd-rom, usb, and pxe over ethernet watchdog programmable watchdog timer for system recovery i/o interfaces accessible from the front panel dual 10/100/1000basetx, dual usb 2.0, access to both pmc sites 2 i/o interfaces routed to optional rear plug-in board vga, ide, com1/2/3/4 (com2 optionally rs-422), dual serial ata, keyboard, mouse, and dual usb 2.0 ports ( routed through j5) two gb ethernet ports in compliance with picmg 2.16 (routed through j3) access to both pmc sites xpdrio rear transition module optional rear i/o interface board (rtm) with: one usb connector 40-pin ide connector two rj-45 connectors for gb ethernet one sata connector com 1,2,3,4 connector (com3 has rs-422 option) ps/2 keyboard mouse vga audio in and out two optional pmc interface (pim) modules xpdrio2 rear transition module optional rear i/o interface board (rtm) with: two usb connectors optional 40-pin ide connector two rj-45 connectors for gb ethernet one sata connector on front panel plus a 1.8" sata drive connector for mounting onboard com 1,2 optional com3, 4 (com3 has rs-422 option) ps/2 keyboard mouse option vga two optional pmc interface (pim) modules operating temperature the CPD2 has a standard operating temperature range of 0/+70 c extended temp versions are available rugged/conduction-cooled versions crd2 is a conduction-cooled version of the CPD2 convection-cooled and conduction-cooled versions have conformal coating as an option net weight approximately 15 oz power requirements 1.5 ghz l7400: +5vdc @5.5a peak, 3.3vdc@2.0a steady 3.0vdc lithium coin cell @3.4 a 2.16 ghz t7400: +5vdc @8.0a peak
dynatem inc., (800)-543-3830, (949)855-3235, fax: (949)770-3481, email: sales@dynatem.com , w eb: www .dynatem.com CPD2 i/o routing i/o front panel through j3 through j5 ps/2 mouse/kybd 1 1 gb lan (4 total) 2 2 (picmg 2.16) com por ts 2 + 2 (optional) vga graphics 1 usb 2.0 2 2 serial ata 2 ide interface 1 (optional) pmc i/o 2 1 1(pmc/xmc (optional) 3
dynatem inc., (800)543-3830, (949)855-3235, fax: (949)770-3481, email: sales@dynatem.com , web: www.dynatem.com ordering information: par t# description cpdwrs compactpci single-slot processor with 1.5 ghz core2-duo, 2 gb ddr-400. with compactpci, picmg 2.16, ipmi. with 16 gb nand flash installed xxxxsx upgrade to 4 gb ddr2-400 xxxxxt upgrade to 2.16 ghz cor e2 duo t7400 xxxxxxx-er extended operating temperature concoa t conformal coating option xpddrio optional rear i/o interface board xpddrio2 optional r ear i/o interface board 4 xpdrio rtm i/o interface xpdrio2 rtm i/o interface
|
